Coolmax CN-330 Manual

General Description Contacts Table of Contents I. Setting up of COOLMAX CN-330 II. Assigning an IP address to the COOLMAX CN-330 III. Map COOLM

NFS Access You could check “Allow for all” to allow all clients access to the NFS server. Or you can add client PCs IP address/Subnet mask to the per

System setting There are eight sections included in “System Setting”, which are “LAN Settings”, “Time Setting,”, “RAID Setting”, “Turn Off Server

Acquire a unique IP address, Subnet mask, and Default gateway information from your network system administrator. Then fill in the information to the

RAID Setting COOLMAX CN-330 supports RAID type 0, 1 and 5 depending on the hard driver amount. If COOLMAX CN-330 only plugs in one hard driver,

Turn Off Server To restart the server, click the “Restart” button. To power off the server, click the “Shutdown” button. Disk Usage Collects and d

 Check Interval: You can select intervals from hourly to daily to have the system perform checks. Email Notification Setting:  Enable: Enable not

Network Service DHCP Server To enable DHCP Server, take the following steps:  If COOLMAX CN-330 failed to get an IP address from the exter

Bonjour COOLMAX CN-330 supported Apple Bonjour protocol and Apple iTunes server. Check Enable box to enable Bonjour protocol. Check iTunes Ena

Setting up COOLMAX CN-330 Assigning an IP Address: This COOLMAX CN-330 has DHCP function built in. The default setting is DHCP client 192.168.1.1.

BTorrent COOLMAX CN-330 supported BTorrent P to P download function. You can download the seed to the system by inputting the correct path and the s

Maintenance Five sections are included in Maintenance: “Disk Utility”, “Firmware Upgrade”, “Save Configuration”, “Restore Configuration”, and “Factor

Firmware Upgrade This function shows “Current Firmware Version”. You can download the latest firmware version to the system by inputting the corre

Save Configuration This function will back up the current system configuration to a local disk and save it in a specified file name. The default

Restore Configuration When the system configuration is destroyed, lost, or incorrectly changed, you can restore the system configuration that you

Factory Reset Factory Reset will reset the system configuration to factory default configuration. When this button is pressed, all users, networ

3.2.7 Log File Five sections are included in Log File: “Samba Log”, “FTP Log”, “DHCP Server Log”, “System Log”, and “Administration Log”. Samba Log

FTP Log

DHCP Server Log

Log in using the SAMBA User Account which is created by you. The network drive can be found on client’s system.

System Log: Specify the destination Linux PC that you want to redirect system log file.

Administration Log

Account Account is the only section in the “Personal Information” tab. You could change the password and user ID, ‘admin’, and the language shown

Logout

Operating COOLMAX CN-330 through GUI Web Interface Once the COOLMAX CN-330 is connected to the network, use the browser (supports Microsoft Inte

After logging into the COOLMAX CN-330 by browser, there are 3 main selections: “Basic”, “Control panel”, and “Personal Info”. Related items and expan

Maintenance  Disk Utility  Firmware Upgrade  Save Configuration  Restore Configuration  Factory Reset Log File  Samba Log  FTP L

To add user support, select the Add User chapter for setting. Please refer to Users and Groups chapter for more detail. To add group support, sel

name and click the “Delete Group” button to delete a specified group. To add or remove users from an existing group, highlight the group name and cli

Share Management It shows all existing shared names; “public” was the factory default share name located at system/shares/public directory. Create